即梦4.5/智能尺寸
铸铝门安装流程 / Installation Process of Cast Aluminum Door 一、安装准备 / 1. Pre-installation Preparation 1. 门洞复核 / Check the door opening 上下中三点测量宽度取最小值，两侧测量高度；门洞对角线偏差≤3mm，垂直度≤2mm/m。 Measure width at top, middle and bottom and take the minimum value; measure height on both sides. Diagonal deviation ≤ 3mm, verticality ≤ 2mm/m. 2. 门体检查 / Inspect door assembly 检查门框、门扇有无变形、掉漆、磕碰，确认铰链、锁具等五金配件齐全。 Check door frame and leaf for deformation, paint peeling and dents. Make sure all hardware such as hinges and locks are complete. 3. 工具与辅料 / Tools & Accessories 工具：激光水平仪、电锤、M12膨胀螺栓、扳手、橡胶锤、胶枪 Tools: Laser level, electric hammer, M12 expansion bolts, spanner, rubber mallet, caulking gun 辅料：不锈钢螺丝、发泡胶、耐候密封胶、木楔、垫块 Accessories: Stainless steel screws, foam sealant, weather-resistant sealant, wooden wedges, spacers 二、门框安装 / 2. Door Frame Installation 1. 就位与粗调 / Position and preliminary adjustment 将门框放入门洞，垫上木楔；两侧预留缝隙10–15mm，顶部预留10–20mm。 Place the frame into the door opening and pad with wooden wedges. Reserve
商AI 生成仅供参考，未经安全版权审查，请勿擅用。
AI改图
下载
更多
描述你想生成的图片信息，如：画面里有什么风格/元素/色彩

暂无同款作品